Written by In today’s world many people know that plumbing is an important part of the construction of the building and without plumbing a house is considered incomplete, however, many people do not even know the basic about the plumbing.
In today’s world many people know that plumbing is an important part of the construction of the building and without plumbing a house is considered incomplete, however, many people do not even know the basic about the plumbing. Very few people try to find or understand the different basics of the plumbing system.The plumbing system as a whole is made up of different pipes, fixtures, joints, parts and subsystem, which overall work together to make an efficient system. There are basically three different types of plumbing systems or subsystems that work in the home. These three types of plumbing systems are supply lines, water drainsand the vents. It is often said that these are the main core of the plumbing system and if either one of them goes missing then wholeof the system would fail to work efficiently and effectively.
Among these three different subsystems the waste drain and the vent pipes are interlinked with one another, that is, they affect the performance of each other and you cannot have one without having the other.Firstly let’s take a look at the supply lines. The lines have the job of carrying clean hot and cold water from the boiler and the water tank at the rooftop respectively to the desired outlets present inside the home, like bathrooms, kitchen and any other place where there is a tap and water is needed. The water in these pipes moves under the force of pressure if the water is coming down from the tank present at the top, however, on the other hand, if the water is being pumped tothe tank from the bottom then the work is being done against gravity and this pumping pressure is created by the water motor which is responsible for filling the tank with clean water. This supply system is usually made of three kinds of pipes, namely, copper, PEX, PB.The second type of subsystem is the drainage system.
It is designed to carry the waste water from the toilets and sinks etc to the underground pipes of the home and then out to the public drainage lines. Water in these pipes flow under the effect of pressure and gravity when toilets operate, otherwise there is only the effect of the gravity which is responsible for the flow of the waste water. This system is made up of two types of pipes
, CPVC or wrought iron.The third type of the plumbing system present in the home is the vent drains. These drains are present at the roof tops of the buildings and these are quite necessary for the drainage system to work properly as this plumbing system is responsible for the release of the toxic gasses from the drain pipe so that the pressure doesn’t build up and hampers the flow of the waste water.These are the three different types of plumbing subsystem which work together to provide the user or the owner of the home with a good and efficient plumbing system.
Source: Free Articles from ArticlesFactory.com
ABOUT THE AUTHOR
Visit langley plumbing, water heater installation vancouver
Last modified: October 28, 2016
